I'm trying to see if my disks will spin down after a period of time. So far no good. Is it possible to see which process is using the disks? Running the script I just get this.
da0 is my USB key that FreeNAS is running from I assume.
I have "Enable powerd (Power Saving Daemon)" enabled in the advanced settings. For each disk I have "HDD Standby" set to 5. I have Advanced Power Management disabled for all. Acoustic Level disabled. SMART enabled. Extra smart options are "-m root".
All drives are the same, info from camcontrol below.
I've got minidlna and PLEX installed. Apart from that I've got a ZFS RAID10 mirror setup.
Code:
camcontrol: error sending command da0: UNKNOWN ada0: SPINNING ada1: SPINNING ada2: SPINNING ada3: SPINNING camcontrol: error sending command da0: UNKNOWN
da0 is my USB key that FreeNAS is running from I assume.
I have "Enable powerd (Power Saving Daemon)" enabled in the advanced settings. For each disk I have "HDD Standby" set to 5. I have Advanced Power Management disabled for all. Acoustic Level disabled. SMART enabled. Extra smart options are "-m root".
All drives are the same, info from camcontrol below.
Code:
pass0: <WDC WD30EZRX-00DC0B0 80.00A80> ATA-9 SATA 3.x device pass0: 300.000MB/s transfers (SATA 2.x, UDMA6, PIO 8192bytes) protocol ATA/ATAPI-9 SATA 3.x device model WDC WD30EZRX-00DC0B0 firmware revision 80.00A80 serial number WD-WCC### WWN 5001### cylinders 16383 heads 16 sectors/track 63 sector size logical 512, physical 4096, offset 0 LBA supported 268435455 sectors LBA48 supported 5860533168 sectors PIO supported PIO4 DMA supported WDMA2 UDMA6 Feature Support Enabled Value Vendor read ahead yes yes write cache yes yes flush cache yes yes overlap no Tagged Command Queuing (TCQ) no no Native Command Queuing (NCQ) yes 32 tags SMART yes yes microcode download yes yes security yes no power management yes yes advanced power management no no automatic acoustic management no no media status notification no no power-up in Standby yes no write-read-verify no no unload no no free-fall no no Data Set Management (DSM/TRIM) no Host Protected Area (HPA) yes no 5860533168/5860533168 HPA - Security no
I've got minidlna and PLEX installed. Apart from that I've got a ZFS RAID10 mirror setup.