Hi All,
I'm trying to flash a 9240-8i to IT mode (9211IT) using the instructions posted here:
http://www.servethehome.com/ibm-serveraid-m1015-part-4/
I've done this before on a previous 9240-8i I owned, but a buddy of mine just ordered one for me to setup FreeNAS - Figured IT 9211 is the best as FreeNAS forums seems to prove passing raid through to FreeNAS is NOT ideal.
Anyway; The issue I'm having is that when i go to flash it using the same instructions above; I'm now getting an error:
I'm using the Top set of instructions:
Any Ideas? I'd really like to have this fixed and working for him - Or am I SoL and cannot flash it to act as an HBA?
Thanks!
I'm trying to flash a 9240-8i to IT mode (9211IT) using the instructions posted here:
http://www.servethehome.com/ibm-serveraid-m1015-part-4/
I've done this before on a previous 9240-8i I owned, but a buddy of mine just ordered one for me to setup FreeNAS - Figured IT 9211 is the best as FreeNAS forums seems to prove passing raid through to FreeNAS is NOT ideal.
Anyway; The issue I'm having is that when i go to flash it using the same instructions above; I'm now getting an error:
- Error: Firmware image does not support Target Adapter Chip Revision (1)
I'm using the Top set of instructions:
- Type in the following exactly:
- megarec -writesbr 0 sbrempty.bin
- megarec -cleanflash 0
- <reboot, back to USB stick >
- sas2flsh -o -f 2118it.bin -b mptsas2.rom (sas2flsh -o -f 2118it.bin if OptionROM is not needed)
- sas2flsh -o -sasadd 500605bxxxxxxxxx (x= numbers for SAS address)
- <reboot>
- Done!
Any Ideas? I'd really like to have this fixed and working for him - Or am I SoL and cannot flash it to act as an HBA?
Thanks!